Bonaire Touchpad Control (LV) - Tekelek - Manual (Page 12)

Touch Pad Control
Ducted Evaporative Air Conditioning
TEK600 Series Control Page 12
Operating the Touchpad
To operate your touch pad control simply press the operating area required firmly until a “Beep” is heard. The unit
will then display the next available options or it will be ready to operate.
If the unit does not start immediately and the snow flake and fan icons are flashing, the unit will be going through
the pre-cool mode setup up by the installer.
MANUAL MODE
Step 1 Press the ON / OFF button to turn the unit on.
Step 2 The Appliance will be in cool mode.
Step 3 To select the COOL (Fan and Pump) or FAN mode
touch anywhere in the MODE outline and the
available icons will be illuminated.
Step 4 Press COOL or FAN. The selected icon will stop
flashing. The remaining icons will flash 3 more
times and then disappear.
Step 5 To adjust the air output use the to
adjust the air output. The level of adjustment is
measured by the bar graph display.
BOOST MODE
Boost mode is an option to run unit in cool mode at maximum
speed.
Step 1 To select the BOOST touch anywhere in the MODE
outline and the available icons will flash.
Step 2 Press BOOST to select the MODE and the icon will
stop flashing. The remaining icons will flash 3 more
times and then disappear.