AMT Datasouth Fastmark 4000 - Manual (Page 32)

User's Guide 31
Resetting the Printer to Factory Default Settings
To reset the printer to its factory defaults after certain commands have been sent or settings
changed:
1. Power off the printer.
2. Press and hold the CANCEL/RESET button.
3. Power on the printer.
4. As the printer turns on the printer will:
FM 4402: All the LED's will come on with the Ribbon LED will begin flashing.
FM 4602/4603: The printer will display “E2PROM RESET …” on the LCD
and the READY LED will blink.
5. When the “READY” LED stops blinking and is continually on the printer's
initialization is completed. On the FM4602 and FM4603 models the Display will
indicated "READY" on the LCD.
6. The following parameters reset to Factory Defaults.
- Label parameters
- Heat (Darkness)
- Speed
- Symbol set (language)
- Others for specific emulation
Notes:
1. All settings stored in non-volatile E2PROM are not erased when the printer looses
power.
2. Mechanical positions of the Switches on the back of FM 4602 and 4603 are not
changed with this procedure.
3. It is necessary to do a Label Sensor Calibration following a Reset.
4. The label count printed during the Self-Test can not be reset.