AMT Datasouth Fastmark 4000 - Manual (Page 25)

24 User's Guide
Changing Position of the Media Supply Spindle
The printer can store under the Media Access Cover an 8-inch outer diameter media roll that
is wound on either 1.5 inch or 3 inch inner cores. When the Media Access Cover is closed
touching on either the Media Cover or the bottom of the printer could cause unnecessary drag
on the form. The printer's Media Supply Spindle can be moved to accommodate these
issues.
To change the position of the Media Spindle:
1. Turn off the printer.
2. Remove the media from the Media Spindle.
3. Using a Phillips Screwdriver remove the 4 screws holding the Media Spindle to the center
of the printer.
4. Slide the Media Spindle to the appropriate position.
1.5 inch inner core: Media Spindle needs to be in the Lower position.
3-inch inner core: Media Spindle needs to be in the Upper Position.
5. Using a Phillips Screwdriver, install the 4 removed screws.
6. Reload the Media into the printer.
Figure 18 - Media Spindle Location
Upper Position
Lower Position