American Energy Systems Country Flame Little Rascal - Manual (Page 6)

Version 1.0c 6
25. This unit’s exhaust system works with a negative combustion chamber pressure and
a low positive flue pipe pressure. It is very important that the exhaust system be
properly installed and air tight. The flue pipe joints should be sealed. Use high
temperature RTV (500
0 F) (260 0 C) silicone sealant or aluminum flue tape and
secured each joint with at least (3) sheet metal screws. Improperly installed stove
flues are the major cause of home fires.
26. When installed in a mobile home, a pellet stove must be grounded to the steel
chassis of the mobile home and bolted to the floor in compliance with and
according to H.U.D. requirements.
27. SOOT AND FLYASH: The products of combustion will contain small particles of
flyash. The flyash will collect in the exhaust venting system and restrict the flow of
the flue gases. Incomplete combustion, such as occurs during start-up, shut down,
or incorrect operation of the room heater will lead to some soot formation which
will collect in the exhaust venting system. The exhaust venting system should be
inspected at least once every year to determine if cleaning is necessary.