American Energy Systems MF3650 Exhaust Blower - Manual (Page 3)

F:\AESBusinessSystems\AES Technical\Piece part instructions\MF3650 Exhaust Blower 2-
speed.doc
• Remove any loose debris from the exhaust tube mounting onto the unit.
• Prior to mounting on the stove inspect the gasket to make sure it has not been damaged if
it has you need to replace the gasket MF3610.
• Install onto unit using the (5) ¼-20 x ¾” hex bolt see picture below for location for each
unit. Pictures looking in from the control panel side.
• Connect wires per instructions connect the wire lead from blower to the white lead from
the wire harness, depending on customer requirement connect the black lead of the
blower to the pink lead from wire harness this will give you the highest CFM from the
exhaust blower, if you connect the red lead of blower to the white lead of the wire
harness this will give you a lower CFM from the exhaust blower. The 6500 would
require blower to be wired for the highest CFM and units that are burning poor quality
fuel requires the highest CFM. (DO NOT EVER USE BOTH RED AND BLACK
LEAD FROM BLOWER TOGETHER THIS WILL DAMAGE THE BLOWER)