ADLINK ACL-8454/12 - Manual (Page 14)

6 • Installation & Configurations
2.2 Unpacking
Your ACL-8454 card contains sensitive electronic components that can be
easily damaged by static electricity. The card should be unpacked on a
grounded anti-static mat. The operator should be wearing an anti-static
wristband, grounded at the same point as the anti-static mat.
Inspect the card module carton for obvious damage. Shipping and handling
may cause damage to your module. Be sure there are no shipping and
handing damages on the module before processing.
After opening the card module carton, extract the system module and place
it only on a grounded anti-static surface component side up.
Again inspect the module for damage. Press down on all the socketed IC's
to make sure that they are properly seated. Do this only with the module
place on a firm flat surface.
Note : DO NOT APPLY POWER TO THE CARD IF IT HAS BEEN
DAMAGED.
You are now ready to install your ACL-8454.
2.3 PCB Layout of ACL-8454
Figure 2.1 PCB Layout of the ACL-8454