Denon DN-V310 - Manual (Page 14)

7
ENGLISH
(2) Connecting to a TV or Monitor Equipped with Color Component Input Connectors
AUDIO IN
L R
COMPONENT VIDEO IN
Y P
B
/C
B
P
R
/C
R
Color component output connectors (PR/CR, PB/CB and Y)
The red (PR/CR), blue (PB/CB) and brightness (Y) signals are output independently, achieving more
faithful reproduction of the colors.
• The color component input connectors may be marked differently on some TVs or monitors (PR,
PB and Y/R-Y, B-Y and Y/CR, CB and Y, etc.). For details, refer to the TV’s operating instructions.
• If your TV is compatible with progressive scan, press the “SHIFT” and “HDMI RES.” button on the
front panel so that “P.SCAN” lights on the display. This results in a high quality picture with little
flickering.
DN-V210/DN-V310
TV
NOTES:
• Use the three commercially available video cords to connect the DN-V210/DN-V310’s color component output
connectors to the TV or monitor.
• Set the “TV TYPE“ in “VIDEO SETUP“ in “SETUP“ to comply with your TV’s video format. When the TV is NTSC
formatted, set to NTSC. When the TV is PAL formatted, set to PAL. (See page 24.)
• Set the “480p/576p” in “HDMI RES.” in “VIDEO SETUP” in “SETUP” to comply with Progressive TV.
• Set the “TV ASPECT” in “VIDEO SETUP” in “SETUP” to comply with your TV’s aspect. (See page 24)
• No audio signals are output from the DN-V210/DN-V310’s “AUDIO OUT” connector when discs recorded in DTS are
played.
• When VIDEO OUT in the VIDEO SETUP menu is set to “RGB,” component video is not output. (Europe model only)