Datalogic Scanning GRYPHONTM MX30 - Manual (Page 72)

Enter Configuration Exit and Save Configuration
М$+;О
DATA FORMAT
М$-?О
C USTOM C ODE I DENTIFIER
define custom code identifier(s)
МEH/О
Read the above code.
(Code Identifiers default to Datalogic standard, see table on previous page).
Select the code type from the code table in Appendix B for the identifier you want to
change.
You can define 1 or 2 identifier characters for each code type. If only 1 identifier character is
required, the second character must be selected as FF (disabled). Read the hexadecimal
value corresponding to the character(s) you want to define as identifiers for the code
selected in step : valid characters are in the range 00-FD. For Wedge and USB-KBD
interfaces, it is also possible to read the Special Key(s) on page 65.
Example:
To define Code 39 Code Identifier = @
define custom code identifier(s) Code 39
Read
МEH/О
+
ÌVWÎ
+
40 + FF
62