Datalogic Scanning GRYPHONTM MX30 - Manual (Page 30)

GRYPHON™ Dx30/Mx30
4
First STAR-System™ Address 5.
ÌRSRÎ
Read the code above and the four-digit address of the First STAR-System™
device in the system.
Set Last STAR-System™ Address 6.
ÌRTTÎ
Read the code above and the four-digit address of the Last STAR-System™
device in the system.
NOTE
e station addresses (steps 5 and 6) must have
the same value.
Whenever the system is composed of a single base station, the
first and last bas
Exit and Save Configuration
М$-?О
EAD BARCODES.
To change the defaults see par. 4.8.
7.
END of procedure.
YOUR READER IS NOW READY TO R
20