Datalogic Scanning GRYPHONTM MX30 - Manual (Page 25)

CONFIGURATION
4
4.3 GRYPHON™ DX30 SETUP
1.
Read the restore default parameters code below.
Restore Gryphon™ Dx30 Default
Ì$+$*oÎ
After reading the above code, go to par. 4.6 Interface Selection.
4.4 GRYPHON™ MX30/OM-GRYPHON™ STAND ALONE SETUP
Read the restore default parameters code below.
Restore Gryphon™Mx30 Default 1.
Ì$+$*oÎ
2. Read the codes below to set the radio address of the Gryphon ™ Mx30 reader.
Enter configuration
М$+;О
Set Radio Address 3.
ÌRA0RFHÎ
+
four digits for the Gryphon™ Mx30 Address (from 0000 to 1999).
All readers used in the same area must have different addresses.
Exit and Save configuration 4.
М$-?О
15