Aiwa Z-R555 - Manual (Page 14)

PROGRAMM
3,7,8,9
Selected disc
number Program number Remaining time on side A
Jf\ 5 F'-01
Selected track number
O
-24:54
Programmed tracks number
6 Repeat step 5 for the rest of the tracks for side
A.
A track whose playing time is ionger than the remaining time
cannot be programmed.
7 Press EDIT/CHECK while pressing SHIFT on the
remote control to select side B and program the
tracks for side B.
in the Programmed edit recording function the tracks can be
programmed whiie checking the remaining time on each side of
the tape as the tracks are programmed.
1 Insert the tape into Deck 1.
Insert the tape with the side to be recorded on first facing out
from the unit, and wind up the tape with ◄◄.
2 Press CD and load the disc(s).
3 Press EDIT/CHECK twice while pressing SHIFT
on the remote control.
“EDIT” and “PRGM” are displayed.
/PRGNC... 00
• When “Al” is displayed, press EDIT/CHECK while pressing
SHIFT again.
4 Press numbered buttons on the remote control
to designate the tape length.
10 to 99 minutes can be specified.
• ►► or MULTI JOG are also available to designate
the tape length.
Tape side A Maximum recording
Tape length (front side) time for side A
F'RGMC...60
O'
H
........40;; 00
5 Press one of DISC DIRECT PLAY 1-5 to select a
disc.
Then, press numbered buttons 0-9 and +10 on
the remote control to program a track.
To select disc 4 or 5 from the remote control, press DISC
DIRECT PLAY 4 or 5 while pressing SHIFT.
Example: To select the 10th track of disc 2, press DISC
DIRECT PLAY 2, then press +10 and 0.
Tape side B (reverse side)
ppPj) F/B................... 3 0 0 0
8 Press EDIT/CHECK while pressing SHIFT to
select side A and press # on Deck 1.
l:n«i flashes for 10 seconds, and then CD play and recording
of edited tracks for the first side start simultaneously. When
the end of the tape is reached, Deck 1 enters the recording
stop mode. After entering the recording stop mode, go to
step 9.
9 Press EDIT/CHECK while pressing SHIFT on the
remote control for recording of the second side.
“B” is dispiayed.
10 Turn over the tape in Deck 1 and press '
recording.
Recording starts.
to start
To stop recording
Press U/± on Deck 1. Recording and CD play stop
simultaneously.
To check the order of the programmed track numbers
Before recording, press EDIT/CHECK whiie pressing SHIFT on
the remote controi to select side A or B, and press ◄◄ or I
repeatediy.
Disc number Program number
JH 5 P......0i
Track number Programmed track numbers
To change the program of each side
Press EDIT/CHECK while pressing SHIFT on the remote controi
to select side A or B, and press ■ CLEAR to ciear the program
on the selected side. Then program tracks again.
To clear the edit program
Press ■ CLEAR twice in stop mode so that “EDiT” disappears
on the display.
13
ENGLISH