American Dryer Corp. AD-100 - Manual (Page 17)

1, To replace main door
a. Remove screws holding main door to the main door hinge block.
b. Replace with new door,
2, To replace door glass gasket (optional)
a. Press narrow slot of door gasket on to edge of door panel, cut out
starting at the bottom.
3, To replace main door glass
a. Start at the seam of door gasket at bottom of door, and spread
the gasket with a blunt blade made of plexiglass or wood, and
insert the edge of the glass. Work around the gasket with the
tool just ahead of the glass.
4, To replace door handle magnets
a. Remove flat head bolt from side of door handle.
b. Remove and replace magnets.
WNUAL RESET IHERmSTAT:
This thermostat will open the heating unit circuit if
an excessive temperature occurs. The motors will run, but dryer will not heat.
A short cool-down period may be necessary before the push button can be reset.
Corrective action should be taken before attempting to restart the dryer. The
manual reset is located in the box housing adjacent to the lint trap in the
lint chamber. (Page 9-7, Figure 5).
TO REPLACE
mWM
RESET:
a. Turn power off.
b. Loosen screws securing bracket to dryer.
c. Remove bracket.
d. Remove screws securing manual reset to bracket.
e. Remove wires to manual reset.
f. Replace manual reset, reverse procedure for installing.
TO REPLACE TUFIHIR OR TUMBLER SUPPORT:
1. Remove lint door (Page 9-5, Figure 1)
a. Open lint door and lift out of slots in base.
2. Open control door (Page 9-3, Figure 1)
a. Remove screws and swing door up.
b. Disconnect control door support rod from its holder, and insert
rod end into hole in control door stiffener.
I^IN DOOR:
(Page 9-4, Figure 10)
8-5