American Dryer Corp. AD-100 - Manual (Page 14)

OPEN CLOSED
No. 1 Reverse/No Reverse Seiectability
No. 2 Add 4 Seconds Rev. Stop --
No. 3 Add 8 Seconds Rev. Stop --
No. 4 Display Temperature
No. 5 Auto/lianual Auto Only
No. 6 Display Degrees F° Display Degrees C°
No. 7 1 Reverse Per Minute 2 Reverses Per Minute
No. 8 Auto Dryness X 3 Auto Dryness X 1
50
OR
60 HZ,
Phase I - For 50 HZ, open dip switch #6. For 60 HZ, close
Phase II - No dip switch change is required.
REVERSING DRYERS
Dryers equipped with reversing action are available in two
forms. The first is a continuous reversing, the other offers the operator the
choice of whether reversing action is desired or not. On the reversing selectable
dryer, the letters "SR " appear in the display as the final data entry step.
If reversing action is desired, pressing "ENTER/START" starts the dryer in the
reversing mode; pressing "0" starts dryer operating in a forward rotation only.
The tumbler stop time between rotation is preset lat the factory. However, the
tumbler should come to a complete stop (with a full load of clothes) between
rotating directional changes. If it does not, additional stop time is required.
This is accomplished through dip switches #2 and #3. When using the Phase I
System, with both switches in the open position, six seconds of stop time is
provided. Closing either switch, or both, provides additional time for a
combination of 6, 10, 14, or 18 second stop time. When using Phase II, Switch
Nos. 2 and 3 in the closed position, 6 second stop time is provided. Opening
either switch, or both, provides additional stop time.
Pin No. 9 is for the forward rotation contactor.
Pin No. 8 is for the reverse rotation contactor.
Pine No. 15 is for the impelling contactor.
REVERSES PER MINUTE
(Phase II Only) On dryers equipped with reversing action,
the computer can be set for the number of reverses per minute desired. By
opening dip switch number 7, the dryer will change tumbler direction once ner
minute. Closing switch number 7, reverses the direction twice per minute.
For reversing dryers with "Reverse/No Reverse"
shows "SR__ " (Select Reversing Action) as the final command
REVERSING SpCTABILITY
seiectability, display
during data entry.
A. Press "Enter/Start" if reversing action is desired; or
B. Press "0" for nonreversing. Machine will start the cycle.
Opening Dip Switch Number 1, places the dryer in the reversing seiectability mode.
8-2