Directed Electronics 120XV - Manual (Page 26)

23 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c .
interpreting zone diagnostics
Warn Away responses are not reported by arming or disarming diag-
nostics. If you receive a Bypass notification when arming or a Tamper
Alert notification when disarming, look at the in-vehicle status LED.
Active or triggered zones will be indicated by a pattern of blinks by this
LED.
Example
If Zone 3 was active or triggered, the in-vehicle LED will blink three
times with a two-second pause. Then it will blink three times again,
and repeat until the ignition is turned on.
NOTE: Your system stores the last two triggered zones in mem-
ory. If your system has been triggered but the LED has been
reset by turning on the ignition, your dealer can still recall the
last two zones that were triggered. Contact your dealer for
details.
➜
Zone - Number Dealer-Installed
of LED Flashes Description Options
1 Instant trigger - often used
for hood/trunk pinswitches
2 A heavier impact
detected by the shock sensor
3 Door switch trigger
4 For optional sensors
5 Ignition trigger