Directed Electronics 120XV - Manual (Page 13)

10 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c .
Page notification
The remote control can be programmed to notify the user of a page
(audibly beeping if the vehicle’s status changes, e.g. door unlocked,
engine started, vehicle violation, etc.). Press to select page
On/Off. One beep is page On, Two beeps is page Off. When programmed
off the remote will not give any notification that a page was received
from the vehicle.
To exit programming mode
The remote control will exit programming mode after 2-seconds
of inactivity and will emit 2 long beeps.
u ussiin ng g yyo ou urr ssyysstte em m
The buttons used in the instructions in this manual correspond to the
standard configuration. Remember, this is not the only way your 2-way
remote may be set up. It can be custom configured to meet your
needs.
active arming
You can arm the system by pressing of your 2-way remote for one
second. When the system arms, from the vehicle you will hear a short
siren sound, or chirp, and see the parking lights flash once. If the
power door locks are controlled by the system, the doors will also lock.
While the system is armed, the in-vehicle’s status LED will flash approx-
imately once per second, indicating that the system is actively protect-
ing your vehicle. If you hear a second chirp after arming and note that
➜