Directed Electronics 120XV - Manual (Page 11)

8 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c .
Alarm Page
If the alarm system is triggered while armed, an Alarm Page will be sent
to the remote control. When the remote receives an Alarm Page, the LED
icons will display the alarm system status information and the remote
control will generate beeps.
An Alarm Page alert is a series of 10 or 4 rapid beeps and the Red LED
will illuminate. This will repeat every 100 seconds to alert the user that
the alarm system was triggered and will continue until the alarm page
is cleared.
If the shock sensor or optional sensor has triggered the alarm the
remote will display the alarm page with 6 Red LED flashes and 10 rapid
beeps.
If the trunk, door, ignition, or hood triggered the alarm the remote will
display the alarm page with the Red LED illuminating for 3-seconds and
4 rapid beeps (repeated 5 times)
Page Recognition (Acknowledgement)
To clear a page alert/notification, quickly press any button on the
remote control. This can be performed at any time during or after the
page notification has occurred.
The remote control will not send a command to the system at this time;
it will only clear future repeats of the page notification. The next time
a button is pressed on the remote control it will send a command to
the system.