beautypg.com

Arming while driving, Disarming – Directed Electronics 120XV User Manual

Page 17

background image

14

© 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c .

arming while driving

Your security system can be armed while driving the vehicle! Simply press

on the 2-way remote for two seconds while the vehicle is running.

The siren will chirp once to indicate that the security system is armed, and

then once more to indicate that the ignition is on. The system will not

respond to any input except the door triggers, and the starter kill relay (if

installed) will not be activated. Once you have arrived at your destination,

the system can be disarmed by pressing the

or by turning the igni-

tion Off. The siren will chirp twice and the in-vehicle status LED will then

stop flashing. The system can also be disarmed at any time by pressing

.

The remote will respond with the normal arming response plus a diag-

nostic notification because the ignition On. When disarmed the remote

will respond with the normal disarming response.

disarming

To disarm the security system, press

. You will hear two chirps, and

the parking lights will flash twice. If the power locks are controlled by

the system, the doors will also unlock. The siren chirping either four or

five times when disarming indicates Tamper Alert, which is described in

the Diagnostics Section of this guide.

The remote will indicate disarm notification with 2 beeps and 3 flashes

of the Orange LED. If disarming after the system has been triggered,

the remote control will send a diagnostic notification as a reminder.

These diagnostic notifications are: