Directed Electronics 120XV - Manual (Page 21)

18 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c .
panic mode
If you are threatened in or near your vehicle, you can attract attention
by triggering the system with your 2-way remote. Just press for
two seconds, and you will enter Panic Mode. The siren will sound and
the parking lights will flash for the programmed siren duration. To stop
Panic Mode at any time, press on the 2-way remote again.
The remote responds with one flash of the Red LED upon entering Panic
Mode and two flashes of the Red LED upon exiting Panic Mode.
valet ® mode
You can prevent your security system from automatically arming and
triggering by using Valet ® Mode. This is very useful when washing the
vehicle or having it serviced. In Valet ® Mode, the security system will
not arm, even with the 2-way remote, but all convenience functions
(door locks, trunk release, etc.) will continue to work normally.
To enter or exit Valet ® Mode:
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet ® button once within 10
seconds.
The in-vehicle status LED will light solidly if you are entering Valet ®
Mode, and it will go out if you are exiting Valet ® Mode.
The remote will respond with 3 Orange LED flashes on entering and 2
beeps and 3 Orange LED flashes on exiting Valet ® Mode.
DRW-35
➜
➜