Altec Lansing 1715C User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
NOTE-
A high compression ratio and a low
threshold setting may decrease the
system's apparent loudness since peak
signals and parts of the nominal signal
may lie above the threshold. You can
correct this by raising the threshold
level; just rotate the
THRESHOLD
control clockwise.
NOTE-
If you set the 1783'3 output level con
trol at its MAX (full clockwise) level, the
output level is -rSdBm. However, this
level only applies if you use a 100
mvrms reference level on the input of
the output module from the mix output
bus. It also only applies if you have a
balanced 600 U load.
6. If you installed the
1783
line output
module, adjust the output level control on
the
1783
for the desired output level. The
higher the output level, the better the
signal-to-noise ratio. However, too high a
level reduces the available headroom and
may cause premature clipping.
WARNING-
Repair performed by other than auth
orized warranty stations (dealers) or
qualified service personnel shall void
the warranty period of this unit. To
avoid loss of warranty, see your near
est ALTEC LANSING authorized deal
er. You can also call ALTEC LANSING
CUSTOMER SERVICE authorized deal
er. You can also call ALTEC LANSING
CUSTOMER SERVICE directly at
405/324-5311, FAX 405/324-8981, or
write:
10500 W. RENO
OKLAHOMA CITY, OK 73128 U.S.A.
12