Audiovox PR-130 - Manual (Page 14)

FUNCTION
IH. AUTO REDlALi ON
IDEFAIP
I. AUTO LOCK
. 1 MIN BEEP
KANYANSWEKON
|OFF
|OFF
HOWTO USE
ON
OFF
ON
The phone will automatical-
' ly redial any number called]
that is not connected, (busy
cell site are out of service) It|
will perform this function 10
times before automatically!
stopping.
You have to manuallyj
request the redial function.
ё Example
OFF
L LONG DTMF [ON
The phone will be locked
whenever you turn it on. It|
must be unlocked by enter­
ing your 3 digits un-lock
code before you use it
(In the locked state, you can
receive calls but not make]
calls.)
The phone can be used
when turned on.
ON IA beep is generated everyj
60 seconds during conver­
sation to indicate your talk
time.
OFF
1
No beep is heard.
ON
OFF
ON
OFF
You can answer incoming
calls by pressing any key
except the [PWR] key.
You can only answer callS:
by pressing the [SEND]
key.
The DTMF signal will be
transmitted for as long as a
key is pressed.
The DTMF signal is trans
mitted for about 10 millesec
onds, no matter how long a|
key is pressed.
K) MEMORY EiESTRlCnON'.If this option is set to the ON
mode, you can not access the repertory memory. (Ml. STO,
RCL, ONE and TOW TOUCH,..)If it is set to OFF mode, you
can access all repertory memories.
L) SILENT INCOMING CALLS:If this option is set to ON. the
unit will give the user a visual alert by displaying call and illu­
minating the key pad.
1FCNU4I "ШС1»"
JU3CKCODEJ "ON "HACKUGKT'
U1 "ON" "LONGDTMP
U} "ON” "ANY ANSWER"
lAl "OFF* "1 MIN BEEP'
lAl "OFF" "AUTO LOCK"
IRC« "ON" "AUTO LOCK"
isroi/iojii
The above example shows the change of "AUTOMATIC
LOCK" status. If you press the [STO] as the last key stroke,
above status is saved in memory. But if you press the {CLR]
key, the settings are not saved, and the original status is not
changed. The set status will not be changed even when you
turn off the telephone.
7.5. REVIEW OVERFLOW DIGITS[FCN-5]
In some cases, you will dial numbers greater than 15 digits in
length. The PR130 has a 15 digit display LCD window. Thus
the dialed numbers greater than 15 digits in length cannot be
entirely displayed on the LCD. However, you can review the
hidden digits of the keyed numbers by pressing the [FCN]
and the [51 key,
7.6 REPROGRAMMING LOCK
CODE[FCN-61
TO PROGRAM
TO CANCEL
IFCN]-^[6l+[LOCK CODE)
[NEW LOCK CODE]
[NEW LOCK CODE]
[CLR]
You can change your lock code at any time. When you want
to change your lock code, press the (FCN] then [6] and enter
your current lock code. Then enter your new three digit lock
code two times. If you want to abort the function during pro­
gramming, press the [CLRIkey.
41 Example
IFCNl.lel "LOCK#"
ILOCKCODEi "NEW#"
[NEW LOCK CODE) "VERFr ****
[NEW LOCK CODE] **** "LOCK IS CHANGED"