Audiovox PR-130 - Manual (Page 13)

A) [iACK-UGHT:In the OFF mode, the backlight will never
turn on except under incoming ringing. The default mode is
AUTO mode Backlighting, turns on by pressing any key. It
stays on for 8 seconds.
B) IXING DTMF:If option is set to the ON mode, the DTMF
signal will be transmitted when a key(s) is pressed.
C) ANY KEY ANSWERdf this option is set to the ON mode,
you can answer incoming calls by pressing any key except
the [PWR] key. If option is set off. you can only answer the
call by pressing the (SENDl key.
D) 1 MINUTE BEEP:If this option is set to the ON mode, a
beep is generated every 60 seconds during your conversation
to indicate another minute of call time. In the OFF mode, no
beep is heard.
E) AUTOMATIC LOCK If this option is set to the ON mode,
the phone will be locked whenever you turn the phone off
and then on again. It must be unlocked by entering your
three-digit lock code before the phone can be used for outgo­
ing calls. (In the locked state, you can receive calls but not
make calls) In the OFF mode, the phone can be used when
turned on.
F) AUTOMATIC REDIAL:If this option is set to the ON
mode, the phone will automatically redial any number called
that is not connected, (busy cell site or out of service) It will
perform this function 10 times before automatically stopping.
In the OFF mode, you have to manually request the redial
function.
G) AUTOMATIC CALL TIME COUNTER:If this option is set
to the ON mode, the call time counter is displayed on the
LCD during call of your conversation. In the OFF mode, the
call time counter is never displayed on LCD.
H) AUTO ANSWERiIf this option is set to the ON mode and a
call is received, the phone will answer the call automatically
after the second ring. In the OFF mode, you must press the
[SEND] key or any key in the (ANY KEY ANSWERI mode.
I) OUT-GOING CALL RESTRICT10N:If this option is set to 7.
you can not dial numbers that are greater than 7 digits. If this
option is set to 11, you can not dial numbers that are greater
than 11 digits. In the off mode, you can dial any number.
J) INCOMING CALL RESTRI(niON:If this option is is set to
the ON mode, you can not receive an incoming call. If it is set
to OFF mode, you can receive incoming calls.
7.4. SET THE STATUS OF
TELEPH0NEÍFCN-4]
A. BACKUGHT
FUNCTION DEFAULT
AUTO
B. SILENT ALT
C. MEM RSTRIC
D. INC RSTRIC
HOWTO USE
AUTC
OFF
OFF
OFF
OFF
E.OTG RSTRIC OFF
F. AUTO ANSWER
G. AUTO TIME
Whenever you use the
phone, the back-light will be
lit up.
But, if you don't touch any
button for 10 seconds, it will
turn the backlighting off.
The back-light will never
turn on except under
incoming ringing.
ON
OFF
ON
OFF
ON
OFF
OFF
OFF
OFF
7
OFF
You can use this feature to
enter scratch pad numbers
during a call without trans­
mitting the DTMF tones
You will hear the feedback
tones but your called party
will not
You can transmit the DTMF
tones during a call.
Repetory momory cannot be
accessed.
You can access all repertory
memories.
(MI. STO, RCU ONE and
TWO touch..)
You can not receive incom­
ing calls.
You can receive incoming
calls.
You can dial any number.
You can not dial numbers
greater than 7 digits
You can not dial numbers
greater than 11 digits.
When a call is received, the
phone will answer the call
automatically after 2 rings.
You must press the [SEND]
key or any key in the [ANY
KEY ANSWER] mode to
receive the call.
ON
OFF
The call time counter is dis­
played on the LCD during
your conversation.
The call time counter is nev­
er displayed on the LCD.