Poulan 195 - Manual (Page 6)

ASSEMBLY
(If tool is received assembled, repeat all steps in this section to be sure assembly is correct and is ad­
justed for the operator.)
A. PREPARATION
This Operator's Manual is designed to help you as­
semble the tool and to provide its safe operation. It is
important that you read the entire manual to become
familiar with the tool before you begin assembly.
1. Read your Operator’s Manual
2. Tools you will need:
- Small Hex Wrench provided)
- Large Hex Wrench 5>rovided)
- Adjustable Wrench
- Standard Screwdriver
B. ASSEMBLY STEPS
NOTE: Hardware referred to in the following sections
are shown in actual size in Figure 1,
1. TUBE
a. Place screws into the holes on the front
shroud as shown in Figure 2 .
b. Position locknuts "D.” in lower holes.
c- Hold locknuts “D,” in place; tighten screws
with small hex wrench (provided) just enough
to hold hardware together.
d. Remove the packing cover from the straight
end of the tube if so equipped. Your unit may
not have a packing cover.
NOTE: Make sure the drive shaft does not fall
out of the tube. Dirt on the shaft will significantly
—~-~reduce-the4ife-ofthe-^anitr-4fthe-drive“shaffcialis~^'
out of the tube, clean, re—lubricate, and re—in­
stall. See “Drive Shaft Lubrication” in the Main­
tenance section.
e. Align the bottom gmove on the tube with the
ridge on the lower wall of the engine opening,
f. Turn the arbor shaft at the bottom of ibe tuc«
as necessary to align the square end of the shaft
with the square hole inside the front opening of
the engine. Figure 2 (inset).
g. Firmlypush tube into the engine openinguntil
the nose cone contacts the foam grip. Figure 2 .
h. Tighten screws “A” alternately with the hex
wrench until secure. Figure 2 .
Remove any packing
material that may be
on the end of the tube.
A*
Locknuts D.
Close up view T
SquareHoIfi-
Shaft
Kidge and
bottom groove
It m^ be necessary to
torn the arbor shaft to
align with thesquare hole.
Figure 2
2. HANBLEBAR ASSEMBLY
a. Locate the decal on the handlebar. Align the
mounting block between the arrows on the de­
cal; then, seat the handlebar in the mounting
block.
b. Position cover "I.” between the arrows on the
handlebar and align screw holes.
c. Insert screws “C,” and tighten securely.
NÖTE; Refer to the illustration on the front cover for
proper positioning.
Figure 3
- 6 -