E blade sharpening, G. optional 4 point, 8” blade, Maintenance accessorjes – Poulan 195 User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
E BLADE SHARPENING
A
WAIINING
Always
stop
the
engine
before
sharpening
a
blade. The blade will continue to spin after the
engine
stops
or
after
the
throttle trigger
has
been released. Make sure the blade has stopped
coasting and disconnect ^ark plug before per-
forming work on the blade.
1. Check blades for flatness periodically. Lay
the blade on a flat surface and inspect the blade for
flatness before sharpening. Throw away a blade
that is not flat,
2.
File or grind each edge in the same manner
to maintain a balanced blade. Figure 30,
A
WARNING
Always replace a blade that is bent, warped,
cracked, or damaged in any other way. Never at
tempt
to
straighten
and
re-use
a
damaged
blade. Use only the specified replacement bl^e.
A
WARNING
To prevent the blade from cracking or flying
apart after sharpening, do not file within 1/4
inch of the radii shown in Figure 30.
■CAinnOi^
Wear
protective
gloves
when
handling
or
performing
maintenance
on
the blade to belp avoid injnry.
G. OPTIONAL 4 Point, 8” Blade
A WARNING
Always
stop
the
engine
before
sharpening
a
blade. The blade will continue to spin after the
engine
stops
or
after
the
throttle
trigger
has
been released. Make sure the blade has stopped
coasting
and
disconnect
the
spark
plug
before
performing work on the blade.
A
WARNING
To prevent the blade from cracking or flying
apart after sharpening, do not file within 1/4
inch of the radii shown in Figure 30.
_____
1. The 4 point, 8 inch blade is reversible. When
the cutting edge on one side becomes duÜ, turn the
blade over. "'W^en both sides of cutting edges be
come dull, the blade may be resharpened.
2. Check blades for flatness periodically. Lay
the blade on a flat surfaceand inspect theblaide for
flatness before sharpening. Throw away a blade
that is not flat.
3.
File or grind each edge in the same manner
to maintain a badahced blade. Figure 30.
A WARNING
Always replace a blade that is bent, warped,
cracked, or damaged in any other way. Nev^ at^
tempt
to
strai^ten
and
re—use
a
damaged
blade. Use only the speci^ed replacement blade.
I CAirriON; 1 Wear protective gloves when
handling
or
performing
maintenance
on
the blade to help avoid injmy.
MAINTENANCE ACCESSORJES
FLEXSHAFTLÜBE................................................................................................................................... 952-701570
ÀIRFILTER ............................................................................................................................................ 952-711509
SPARK PLUG.................................................................................................................................. 530-030077
-
22
-
....