Troy-Bilt 682J - Manual (Page 28)

Section
5 Maintenance
A
WARNING
Before inspecting, cleaning or
servicing the machine, shot off engine,
wait for al! moving parts to come to a
complete stop, disconnect spark plog
wire and move wire away from spark
plyg. Remove ignition key on electric
start models.
Failure to follow these instructions can
result in serious personal injury or
property damage.
NOTE: All references to left, right, front
and rear of the machine are determined by
standing behind the handlebars and facing
the direction of forward travel.
REQUIRED MAINTENANCE SCHEDULE
Before Every Every Every As
PROCEDURE Each 1B 25 30 Noted
Use Hours Hours Hours
Check engine oil level Every 5
operating hrs.
Clean engine cooling system
Test operation of Forward Interlock
Safety System
Section 4
Forward Interlock Safety System -
check wire condition,connections
Check electrical connections
#
Recharge battery Before/after
long storage
Check drive belt tension # After initial
2 hours
Check nuts and bolts # After initial
2 hours
Clean tiller tine shaft
Lubricate tiller
Change engine oil* More often
in dusty or
dirty areas
Clean foam element air filter
Check paper element air filter
&
»
More often
in dusty or
dirty areas
Check for oil leaks
»
After initial
2 hours
Check gear oil level in
both transmissions
After initial
2 hours
Check bolo tines for wear
Check reverse disc for wear &
Check air pressure in tires 9
* During engine break-in period, change engine oii after first 2 hours of operation.
28