Ariens GARDEN TRACTORS 931013 S-14G - Manual (Page 3)

DECALS FOR MODELS 931013 & 931014 GEAR TRACTOR
A
warning
]
I Grasp handle, not chain.
78282
S-10 G ONLY
S-10G
78388
P , I ii F R T - ( , T R
L I G H T S I M P L P O W E R
DASH PANEL - 78341
% R T i M G P R O C E D U R E
^CAUTION
RELEASE LIFT ASSIST SPRING
BEFORE DISCONNECTING
I
I ATTACHMENT FROM TRACTOR
+ CAUTION
78367
78281
S-10 G ONLY
COMPLIANCE WITH CANADIAN RADIO INTERFERENCE REGULATIONS CERTIFIED
REPLACE SPARK PLUG WITH RESISTOR SPARK PLUG ONLY !
CERTFIE CONFORME AU REGLEMENT CANADIEN SUR LE BROUILLACE RADIOELECTRIQUE
REMPLACER LA ROUGIE PAR UNE ROUGIE A RESISTANCE SEULEMENT I
78400
(UNDER HOOD, NEXT TO SPARK PLUG)
BE AWARE OF SAFETY DECALS
15. When using any attachments, never direct discharge of
material toward bystanders nor allow anyone near the vehicle
while in operation.
16. Handle gasoline with care—it is highly inflammable.
a. Use approved gasoline container.
b. Never remove the cap of the fuel or add gasoline to a
running or hot engine, or fill the fuel tank indoors. Wipe
up spilled gasoline.
c. Open doors if the engine is run in the garage—exhaust
fumes are dangerous. Do not run the engine indoors.
17. Keep the vehicle and attachments in good operating con­
dition, and keep safety devices in place.
18. Keep all nuts, bolts, and screws tight to be sure the equip­
ment is in safe working condition.
^ 19. Never store the equipment with gasoline in the tank inside a
building where fumes may reach an open flame or spark. Al­
low the engine to cool before storing in any enclosure.
20. To reduce fire hazard, keep the engine free of grass, leaves,
or excessive grease.
21. The vehicle and attachments should be stopped and in­
spected for damage after striking a foreign object, and the
damage should be repaired before restarting and operating
the equipment, see numbers 6 & 7 opposite page.
22. Do not change the engine governor settings or overspeed the
engine.
23. When using the vehicle with mower, proceed as follows:
a. Mow only in daylight or in good artificial light.
b. Never make a cutting height adjustment while the engine
is running if the operator must dismount to do so.
c. Shut the engine off when removing the grass catcher or
unclogging chute.
d. Check the blade mounting bolts for proper tightness at
frequent invervals.
24. Check the grass catcher bags frequently for wear or. de­
terioration. Replace with new bags for safety protection.