Ariens GARDEN TRACTORS 931013 S-14G User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To make the rear rock shaft operational, move the hy
draulic control lever to the "UP" position and hold it there
until the cylinder is fully extended. Place the selector knob in
the front notch (Figure 23).
To make the front and center rock shafts operational,
move the hydraulic control lever to the "UP" position and
hold it there until the cylinder is fully extendi. Place the
selector knob in the rear notch as shown in Figure23.
IN REAR NOTCH - FRONT AND CENTER ROCKSHAFTS
ADJUSTING CHAINS
FOR S10G MANUAL
LIFT, ASSIST SPRINGS
FIGURE 22
A
CAUTION - WHEN ADJUSTING CHAIN TENSION ALWAYS GRASP
CHAIN HANDLE FIRMLY (NOT THE CHAIN) AS CONSIDERABLE TENSION
IS ON THE CHAIN AND INJURY TO THE HANDS COULD RESULT.
HYDRAULIC LIFT REAR ROCK SHAFT
The rear rock shaft comes with a lift selector device so
that the front and center rock shafts can be operated in-
depefidentty of the rear rock shaft while utilizing only one
hydraulic cylinder. The alternately latched, split lift linkage
systeih holds the front and center rock shafts in their raised
positions while the rear rock shaft is operated by the cylinder
.or vice versa. This allows a rear mounted attachment to be
used without removing the front or center mounted attach
ments and vice versa.
c
<