Slant overedge stitch, Edging, Border design – SINGER 9113 User Manual
Page 33: Мие tft
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SLANT OVEREDGE STITCH
With the Slant Overedge Stitch you can stitch and finish a seam in one step. It is also
ideal for edging and appliqueing.
EDGING
Add a delicate touch to your sewing while
finishing and reinforcing your edges.
• Sew seams in usual manner and press.
RECOMMENDED SETTINGS
Stitch Selection:
Slant Overedge
Stitch
Stitch Width:
i
$МИе TFT
Stitch Length:
3-1/2 to 4
Foot:
Special Purpose
(J)
Needle Plate:
General Purpose
(A)
Adjust balance, if necessary
• Place edge of garment, right side up,
under presser foot.
• Bulk of garment should be to the left.
• As you stitch, needle should go over
right edge of fabric, as shown.
ARROW STITCH
(If your machine has this pattern.)
This stitch is a decorative and secure finish to seams, pleats and pockets. It can also
be used as a border design.
BORDER DESIGN
• Sew seams in usual manner and press.
• Mark stitching lines on fabric where
desired.
RECOMMENDED SETTINGS
Stitch Selection:
Arrow Stitch
Stitch Width:
1
1
HBo
Stitch Length:
1
or
lower
Foot:
Special Purpose
(J)
Needle Plate:
General Purpose
(A)
• Center stitching line under presser
foot and sew.
•
• Trim thread ends close to fabric.
31