SINGER 9113 - Manual (Page 17)

• Bring thread from needle, under presser
foot and wind it one turn in any direction,
around presser foot screw (6) pulling it
into spring groove on screw.
Begin running machine at a moderate
speed.
The window in the slide plate lets you
watch the bobbin winding.
When desired amount of thread has
been wound, stop machine. DO NOT
ALLOW THREAD TO WIND BEYOND
THE OUTSIDE “FULL” RING (7).
Remove thread from presser foot screw. •
• Close slide plate, returning machine to
sewing position.
• If your machine has pop-up automatic
positioning button (8), push button down
with your finger while closing slide plate.
• Raise needle to its highest position.
• Pull 4" (10cm) of thread under foot
toward back of machine, and cut.
• To begin sewing, position needle in fabric
where desired, lower presser foot and
start machine.
15