Lower looper (red), Threading – SINGER 14T948DS User Manual

Page 16

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Threading

Lower looper (red)

- Place the spool on the

spool holder pin.

- Bring thread up from back to front

through guide (1)

- Pull the thread under the protector (2)

and pass under the guider up to
go around the pre-tension (3)

- Thread guide (4,5,6)
- Turn the balance wheel

toward you until the lower

looper extending out
5-10mm from the needle
plate edge.

- Pull the thread

with tweezers to pass the

lower looper hole (A).

- Draw the thread with your

left hand tightly.

- Use your finger to push the

automatic threader (B) up to
the topmost,and then
thread goes through the

lower looper (C)

automatically.