SINGER W510 User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

(V. PREPARING

r,-ACi-

WINDING THE BOBBIN

Disengage the hand wheel by holding it

tightly with your left hand and turning
the coupling wheel toward you with your
right hand (Fig. 21). Place the spool on

spool pin (A) , leaving about one foot of
thread free. Lead the thread around the

guide (B) on the back of the machine and
around the bobbin winder tension disc
(C), then thread guide (D) as illustrated

(Fig. 22), and run the end of thread

through a hole on the rim of bobbin.

Place the bobbin on the spindle and push

the bobbin winder to the right. Hold the
thread end securely and run the machine
slowly. Bobbin will stop turning when

filled.

Cut

thread

and

push

bobbin

winder to the left. Remove bobbin from

spindle. Tighten the coupling wheel by
turning it away from you as you hold the
hand wheel in place. The needle should
now move when you turn the hand wheel.

Note: If the bobbin is winding unevenly,

adjust bobbin Winder threed guide
up or down as needed.