SINGER 101-12 - Manual (Page 16)

To Connect Machine 101-12 on Portable Set 204
to Electric Service Line
Push the terminal plug at one end of the eldctric
cord as far as it will go on the three-pin terminal
block at the right of the cabinet as shown at U in
Fig. 13. Attach the plug at the other end of the cord
to the nearest electric socket and the machine is
ready for operation.
To Ensure Perfect Action of the Machine
The balance wheel must always turn over toward
the operator.
Do not run the machine with the presser foot
resting on the feed without cloth under the presser
foot.
Do not run the machine when both bobbin case
and needle are threaded, unless there is material
under the presser foot.
Do not try to help the machine by pulling the
fabric, lest you bend the needle. The machine feeds
the work without assistance.
The slide over the bobbin case should be kept
closed when the machine is in operation.
To Turn SINGERLIGHT “On»» or “Off»»
Reach over the top of the machine and move the
switch lever (V, Fig. 14) to the right or left as
desired.
To Remove and Replace the Bulb
To remove the bulb, hold the SINGERLIGHT
socket tightly with one hand and with the other hand
turn the shade halfway around until the pin (W,
14