SINGER 384.13012 (Sold at Sears) - Manual (Page 14)

GETTING READY TO SEW
Connecting Machine to Power Supply
© Power supply plug © Power switch
© Outlet ® Machine socket
© Machine plug © Light bulb
Before connecting the power cord, make sure the voltage
and frequency shown on the machine conform to your
electrical power.
1. Turn off the power switch ©.
2. Insert the machine plug ® into the machine socket
3. Insert the power supply plug© into the outlet ©.
4. Turn the power switch ©to turn on the power and sewing
light®.
For Your Safety
* While in operation, always keep your eyes on the sewing
area. Do not touch any moving parts such as the thread
take-up lever, handwheel or needle.
* Always turn off the power switch and unplug from the
power supply;
- When leaving the machine unattended.
- When attaching or removing any parts.
- When cleaning the machine.
* Do not place anything on the foot control, when not sewing.
When Finished Sewing
* When you are finished sewing, turn all controls to off (“ О ”)
position, then remove plug from outlet.
* Unplug foot control from machine.
* Lower presser foot lifter.
* Remove needle thread (Top thread). Turn handwheel to
lower needle bar to the lowest position.
* Place your machine out of reach of children in safe, dry
location.
Operating Instructions:
“For appliances with a polarized plug (one blade wider than
the other). To reduce the risk of electric shock,this plug is
intended to fit in a polarized outlet only one way.
If it does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to install the
power outlet. Do not modify the plug in any way.”
“Foot Controller Model YC-482J or TJC-150 is used with
Sewing Machine Models 384.13012XXX."
XXX - represents numbers 000 through 999.
Controlling Sewing Speed
Sewing speed can be varied by the foot control.
The harder you press on the foot control, the faster the
machine runs.
14