SINGER 1200 Athena - Manual (Page 46)

/
Method 1
lifc
lit
sMoîhod 2
APPLIQUE
Make a test sarr^ple to decide which of the
foHowing methods is the most appropriate for
your fabric and design. Mark design on piece
of fabric to be appHqued. Cut out design ieav-
ing about 3/4-inch {2cm) margin ali around.
Position the design.
Baste it to the fabric.
® Set pattern seiector and stitch-width dial for
desired applique stitch. Adjust stitch length
to a fine setting, between 1 and 0.
• Follow the outer edge of the design with a
decorative stitch.
» Trim away the excess fabric on the outer
edges of the stitching.
Hettiod 2
« Select straight stitching.
« Outline the entire design with a short stitch.
e Trim raw edges to the stitching and remove
basting.
• Select stitch pattern and stitch width
desired, and set stitch iength on a satin
stitch setting lor a ciosely spaced stitch,
between 1 and 0.
® Stitch, foiiowing the straight stitch outiine.
This method wlli produce a smooth over-
edged finish, with no raw edges to be trim­
med after stitching.
Method 3
® Purchased motifs can be appliqued quickly
and easily by using either a straight or
decorative stitch.
Method 3
44