SINGER 1200 Athena - Manual (Page 19)

To start sewmg, puli thread back under
presser foot and cut. Place threads diagonally
under foot to left side, position needle In
fabric where desired, lower presser foot and
start machine.
CHAIIGIMQ THE BOBBIH
Remo¥ing tlie BoiJbin
Raise media and take-up lever to its highest
position by turning the hand wheel toward you.
1. Open slide plate; move bobbin iatcn to left.
mder 2. Remove bobbin by Inserting finger
rim of bobbin.
Replacing an Emptf Bobbin
1. Slip bobbin (thread slot on top) Into bobbin
case.
2. Move bobbin latch to extreme right (wind
position).
® Leave slide plate open until you have
finished winding the bobbin.
J^erngving;: Sobbin;:
Thread Slot
Removing Tbread from Bobbin
You can leave the bobbin in plaoe while
removing thread. With slide plate closed, pull
thread end through the plate with a steady
motion. Do not pull the thread across the feed
as this may damage It.
Bepisacing EmptytSdfebifs
17