SINGER W8910 - Manual (Page 7)

Connecting the machine
n _____
V^UllllCV-LXilS LX1& xvjvxx v,v^xxi-iC!i
Remove the cord from the foot control and place the
control under the table. Insert the foot control plug into
the socket on the right side of the machine.
Connecting to the wall outlet
The voltage (V) and frequency (Hz) are indicated
under the base of the machine. Check that these values
correspond to those of the electricity source before con­
necting the machine.
Main switch
The light and the machine are turned on by pressing
the main switch. This makes it easy to see that the
machine is ready for sewing.
Speed control and needle stop-right
The speed is controlled by means of the foot control.
Press the foot control down lightly and the machine will
start sewing at the lowest stitch speed. This speed is
suitable for precision sewing and if you wish to manoeu-
ver the fabric by hand.
When you depress the foot control further the
machine will run faster. The needle has full penetration
power all the time.
When you lift your foot from the control the needle
will always stop at its upper position so it is not necessary
to think about the needle position at the start or finish of
a seam. If you wish to turn the fabric when sewing
around a comer for example, it is easy to get the needle
to stop down in the fabric. Just press the foot control
down quickly and release it again.
I I
---- II---- Ir^l
mmmm
■' N
—
^ 1