SINGER W8910 - Manual (Page 17)

Accessory box
rresser root n, giiae piates
Presser foot H corresponds to presser foot A, with the
exception of the teflon coating underneath. The glide
plates can be adhered to presser feet E and C. Remove
the protective paper and press the self-adhesive side
against the underneath of the presser foot.
Both presser feet may then be used when sewing foam
plastic, vinyl-coated fabric and leather imitations, thus
minimizing the risk of these materials sticking to the
foot.
Changing the presser foot
If you wish to change the presser foot, check that the
needle is at its upper position Remove the presser foot by
drawing it toward you while pressing slightly downward.
Insert the new presser foot in such a way that the
round, horizontal pin fits in between the spring and the
presser foot ankle. Press slightly downward and back­
ward and the foot will snap into place.
Edge guide
The stitch place has markings for 1.0,1.5, 2.0,2.5,3.0
and 3.5 cm, to simplify sewing seam allowances. If you
require an even wider seam allowance, use the edge
euide.
First loosen the screw at the rear of the presser bar as
far as it will go. Insert the guide into the groove under
the screw and adjust it to the required seam allowance.
Tighten the screw, using the screwdriver.
15