Pentax ZX-5N - Manual (Page 99)

In any case, however, shipping charges and customs
clearance fees to be borne by the sender. To prove the
date of your purchase when required, please keep the
receipt or bills covering the purchase of your equipment
for at least a year. Before sending your equipment for
servicing, please make sure that you are sending it to
the
manufacturer's authorized representatives or their
approved repair shops, unless you are sending it directly
to the manufacturer. Always obtain a quotation for the
service charge, and only after you accept the quoted
service charge, instruct the service station to proceed
with the servicing.
The local warranty policies available from Pentax dis­
tributors in some countries can supersede this war­
ranty policy. Therefore, we recommend that you
review the warranty card supplied with your product
at the time of purchase, or contact the PENTAX dis­
tributor in your country for more information and to
receive a copy of the warranty policy.
STATEMENT OF FCC COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause unde­
sired operation.
Changes or modifications not approved by the party responsible
for compliance could void the user's authority to operate the
equipment.
This equipment has been tested and found comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate frequency energy and. if not in­
stalled and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is
no guarantee that interference will occur in a particular installa­
tion. If this equipment does not cause harmful interference to radio
or television reception, which can be determined by turning the
equipment off and on. the user is encourage to try to correct the in­
terference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experience radio/TV technician for
help.
This class B digital apparatus meets all requirements of the
Canadian Interference - Causing Equipment Regulations.