Sears 934.5512559 - Manual (Page 23)

When the programs overlap, Quick Set Program
has priority. But if an another program has been acti­
vated when the start time of the Quick Set Program
comes, the Quick Set program will be begun after fin­
ished the faster program.
If you program as per the illustration the timer record­
ing would be carried out as follows.
9:00AM -11:00AM for PROGRAM 1
11:00AM - 12:00PM for PROGRAM 8
(Quick Set Program)
12:00PM - for PROGRAM 2
TO CHECK THE START/END TIME
To check the start/end time and channel number, first
press POWER/TIMER REC button so that "0" indi­
cator appears, then press QUICK SET PROGRAM
button once. Both the start and end time will appear for
3 seconds each, and return to the Timer Stand-by mcxle.
TO CANCEL A QUICK SET
PROGRAM
• While setting a program; press STOP/EJECT but­
ton on the VCR.
• After setting a program; (power must be on)
First, press QUICK SET PROGRAM button.
Then, press STOP/EJECT button.
• While recording is in progress; press STOP
/EJECT button.
HINTS
• If there is a power failure or the VCR is unplugged
for more than 3 seconds, the clock setting and all
timer settings will be lost.
• If the tape runs out before the end time, the VCR will
switch to the Stop mode immediately, eject the tape
and the VCR power will be turned off. The "0 " in­
dicator will flash.
• If a tape is not inserted or the erase-protection tab is
removed, the "0" indicator flashes and automatic
timer recording cannot occur. Insert a tape that al­
lows recording.
• The TV that is connected to your VCR may be
turned ON or OFF when the VCR is in the timer-re­
cord mode.
2 3 - E N
★ ★ ★ ★ ★ 5C16