Sears 934.5512559 - Manual (Page 14)

CHANNEL MEMORY PROGRAMMING
(Without a Cable Box)
Channel memory programming is NOT needed when connected to a CABLE BOX. You can program the tuner to
scan only the channels you receive in your area.
• You must use remote control for this procedure.
NOTES:
• Follow the steps below, once. Repeat it only if there is a power failure or the VCR is unplugged for more
than 3 seconds. In these cases, since the programmed channels are erased, the VCR will prompt you with
when you turn it on. '
• You must follow the steps below before attempting to play or record a video tape. If you want to play or
record a video tape BEFORE programming the tuner, you must first press POWER button to turn off the
VCR. Then, press POWER button again to turn it back on. To program the tuner again, see "To preset channel
memory again" on this page.________________________________________________________________________
m
Plug the VCR power cord
into a standard AC outlet.
The flashes.
Turn on the TV and set the TV channel to the same
video output channel located on the back of the VCR.
(CH 3 or 4)
m
Press the POWER button to
turn on the VCR so that the
appears on the display.
Press the TV/VCR button so that "VCR" appears on the
display. "LANGUAGE SELECT" appears on the TV
screen.
1X1
Select 1 (ENGLISH) or
2(ESPANOL - SPANISH)
with number buttons.
LANGUAGE SELECT
Press SELECT or MENU
button on the remote control
so that "TUNER SET UP"
appears on the TV screen.
TUNER SET UP
Press SELECT button once. The tuner scans and memo­
rizes all the active channels in your area.
After scanning, the tuner stops on the lowest memo­
rized channel.
The VCR distinguishes between standard TV channels
and Cable channels. If you subscribe to cable TV,
"CATV" appears on the display. (TV mode: from CH2/
CATV mode: from CHI)
8
The TV screen returns to TV mode.
• If you want to recall the selected channels, you can
select the desired channel directly by number but­
tons on the remote control.
• The TV screen returns to TV mode when you press
MENU button in Tuner Set Up mode.
To preset channel memory again
1 Turn on the VCR.
2 Turn on the TV and set the TV channel to the same
video output channel located on the back of the
VCR. (CH 3 or 4)
3 Press the TV/VCR button so that "VCR" appears on
the display.
4 Press MENU button. Select item 3(INITIALIZE)
with number buttons. _____________
CHANNEL SET UP
1 TV (ONI
2 CATV
3 AOeVDELETE CH
5 Select item 1 (CHAN­
NEL SET UP) with num­
ber buttons. And select
1(TV) or 2(CATV) with
number buttons.
6 Press SELECT button once. After scanning, the
tuner stops on the lowest memorized channel.
14- EN
★★★★★ 5B24