Installing sliding guard, Parts needed, Washer – Sears 113.206931 User Manual
Page 9: Mounting switch, Tools needed, Installing sliding guard mounting switch
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLING SLIDING GUARD
PARTS NEEDED
1/2 IN, HEX NUT
Sliding Guard
Sliding Guard Knob
Sliding Guard Rod
Sliding Guard Washers ions side of washer is conca\ie)
Hex. Nut 1/2 in, - 13
Split lockwasher 1/2 in.
Ext. tooth lockwashers
10-32x1/4 Pan Hd. Screws
place
1. Screw nut all the way onto long end of rod
1/2 in. lockwasher next to nut.
2. Screw rod all the way into Jointer with short end up . ..
tighten nut.
3. Attach sliding guard to fence with two machine screws
and lockwashers.
4. Place one Sliding Guard Washer, concave side DOWN on
support rod.
5. Drop sliding guard onto rod . . . place other washer, con
cave side UP on rod . . . screw on Sliding Guard Knob.
WASHER
SLIDING GUARD KNOB (CONCAVE SIDE UP}
10-32x1/4 SCREWS
EXT. TOOTH
LOCKWASHERS
MOUNTING SWITCH
PARTS NEEDED
1 On./Off Power Outlet
2 Pan Hd. Screws, 1/4-20 x 1/2
2 Lockwashers, External 1/4
2 Washers, 17/64 x 1/2 x 1/32
Attach On/Off outlet to infeed table using two tapped
holes.
MOUNTING
RECOMMENDED
CRAFTSMAN
MOTOR AND BELT GUARDS
See page 5 for recommended motors.
PARTS NEEDED
4 carriage bolts,
washers and nuts.
1 Jointer Planer Belt Guard
1 Motor Pulley Beit Guard
1 Belt Guard Support
1 Belt Guard Support Bracket
5/16-18 X 3/4 in., flat washers, lock
3 Belt Guard Clips
1 Motor Pulley, 2-1/2 in. dia.
1 V-Belt
2 Pan Head Screws 10- 32 x 1/2 in.
2 Hex. Hd. Screws 1/4 - 20 X 1/2 in.
2 Hex. Nuts 1 / 4 - 2 0
TOOLS NEEDED
Medium Screwdriver
5/32 in. Setscrew Wrench (furnished with Jointer)
1/2 and 7/16 in. Wrenches
5/8 IN. DIA. SHAFT
1. Place motor on your workbench with 5/8 in. dia. shaft
{with key way} facing you.
2. Attach guard support to bracket with two screws.
NOTE:
The holes in the bracket are not threaded, but
the screws are "thread cutting screws" and will cut a
thread as they are tightened.
PAN HD. SCREWS
SUPPORT
BRACKET
SUPPORT