Getting to ;know your ¡©infer»planer – Sears 113.206931 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
getting to ;know your ¡©infer»planer
: e. Adjust 45? stop in the same manner.
:
NOTE:
Tilt scale will not require adjustment if it
was adjusted for 90*^ position.
HEAD
OF
SQUARE
INFEED
TABLE
. CUTTER GUARD.
Provides protection over the
cutter head. It must aIvvaVs be in place and function
ing properly-
Check the guard to make sure it is functioning pro-
■ perly.-^-. :
■
■
a. Position fence to right for maximum width of cut.
b. Pass a 1/4 in. thick piece of wood over cutterhead
between guard and fence. .
Guard must return automaticaliy to "rest position"
against fence when free of the wood.
If guard does not return automatically, see Trouble
Shooting and Maintenance Sections.
CUTTER
GUARD
CROWNED CUT
). iNFEED TABLEtMUST
ALWAYS BE PARAL
LEL TO THE pUTFEED TABLE.
If the cut edge or surface of the workpiece is
CROWNED, it is an indication that the OUTWARD
END of the INFEED table is HIGH and must be
adjusted.
;
If the cut edge or surface of the workpiece is CON
CAVE, it is an indication that the OUTWARD END
of the INFEED table is LOW and must be adjusted.
Check the infeed table to determiriO the "out of
parallel" condition.
INFEED TABLE LOW
14