Depth of cut handwheel. turning_ilie, Getting to know your joirster-ploner, Stops – Sears 113.206931 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
getting to know your joirster-ploner
WARNING: FOR YOUR OWN SAFETY TURN SWITCH
“OFF" AND REMOVE PLUG FROM POWER SOURCE
OUTLET BEFORE MAKING ANY ADJUSTMENTS,
FENCE TILT SCALE
{BEHIND FENCEI
FENCE
LOCK
KNOB
FENCE
SLIDING
GUARD
KNOB
INFEED
TABLE
SLIDE
BRACKET
ON-OFF
SWITCH
DEPTH
OF CUT
HANDWHEEL
. DEPTH OF CUT HANDWHEEL.
Turning_ilie
handwheel counterclockwise will lower the infeed
table to maximum depth of 1/8 in.
■ ;
: .
DEPTH OF CUT
HANDWHEEL
DOWN
L
FENCE LOCKS AND
stops.
The fence can be
moved across the Jointer to take full advantage of the
"sharpness*'of the blades.
The fence should be positioned to the extreme right
{toWërd pulley) but not beyond the end of the blades.
Most of the cutting {usually jointing) will be done with
-die fence in this position. As the blades become dull,
the fphce can be mowed toward the left where the
blades àrè sharper.
To move the fence, loosen the Fence Lock Knob and
the Sliding Guard Knob and slide to desired position.
Make
sure
SLIDE
BRACKET Is even with surface of
QyjpgEDTABLE.lfitis above or below the surface,
loosen screws and adjust it,
a. Always tighten fence lock knob first to align fence,
then tighten sliding guard knob. ........................
SLIDING GUARD KNOB
PUSH DOWN
WHEN LOCKING
FENCE LOCK KNOB
FENCE
45* FENCE
STOP
90* FENCE
STOP
FENCE
LOCK
KNOB
12
SLIDE BRACKET