Sharpentmg cutter blades, Sharpening cutter blades, Moinfenance – Sears 113.206931 User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
moinfenance
The normal position of guard (at REST) when fence is
stationed at IVIAXtSVlLUVI WIDTH OF CUT, is shown as
"position
"A"
NEVER
ROTATE
GUARD
BEYOND
POSITION "B" BECAUSE THIS WOULD EXERT EX
CESSIVE TENSION ON SPRING WHICH COULD
WEAKEN OR BREAK IT.
Check operation of GUARD and SPRING.
r. With fence in MAXIMUM WIDTH OF CUT position,
pass a piece of 1/4 in. thick wood on edge (jointing
position) over cutterhead.
2. The guard should return autonnatically to its REST
position against the fence when free of the wood.
3, If guard does not return to its REST position, remove
cotter pin from pivot pin and remove guard. Check
pivot pin and hole . . . make sure there are no burrs,
rust, or other foreign matter.
4; Apply a few drops of SAE No. 2p dr No. 30 engine
oil to pivot pin.
5. Replace guard and cotter pin.
(f guard still does not return to its REST position, con
sult your local Sears Retail Store before using the
jointer-planer.
—^
SHARPENtMG CUTTER BLADES
The blades can be honed individually with an ordinary
oilstone. .
■■■:■ ■: ■.
Make sure your oilstone is not worn in the center. It
must be flat.
...............
Be sure to remove the burr on the flat side.
If the blades are nicked, they must be replaced or re
ground. They can be reground several finnes until ihey
fc^corne 9/16 in. wide. Never install regrbund blades less
than
9/16
in. wide.
:
/ ^
Have your knives reground by someone who is com
petent. Look in the "Yellow Pages" of your telephone
directory . . . see "Sharpening Services". .
24