Sears 113.206931 - Manual (Page 11)

8. Snap guard ‘nto position as sóowft.
9. Rt?!'nov8 knoO find vATisher , . , isft gusKii up.
!0. Lt>ost?n Th* two MOTOR BASE CLAMP SCREWS and
wt.ate the motor jo ’hat the ventiislion slots d m fecfpg
downward, tighten base damp screws
11. iristaii thp 2-112" Pulifev on rno’ijt 3nd move the
motor sideways urnd tire motor pulley o aiitpiiid wdh
th-e pulley ora the machíne,
12. in-stati V-Bi’it and PUSH down on motor to apply
tension to !hi: bds arid fighisn nuts on oiotor
mounting bcih'5.
NOTE: It is only necessary to sppty enough scnsion
to the twit to preven! it from ,slsppin m
puiievs white funrcng,
13. After motor and v-beli have been instailcd and adjusted
frsr aiigritTient and tension ipstaH the metei bds guard to
Leg Set using the holes that are letter coded "B" as
d'.ovvr-t on page -S.
14. Insert motor cord plug through rectangular opening in
si-rje stiffener Uiat ■:> directly -ufid-er switch box: ísS'K'á
then into the receptacle. To prevent damage to motor
cor-d attach it to side .stiffeners using the two f2)cofti
dips.
7 VENTILATION HOLES
h FACING DOWNWARD
■ s I
RÍOTOR BASE
CLAMP SCREWS
(BOTH ENDS)
WASHER
(CONCAVE SIDE UPl
JOiNTER-^PULLEY BELT GUARD
IMSTALLATiON
T. Attisch guard to sta-nd with Hex. Hd. .screws and nuts.
Make sure tieit docs not scrat» on gtigrd,
2 . Replace washer CONCAVE side up. . . screw on knob.
11