Replacing cutter blades, Wedge, Lockscrew – Sears 113.206931 User Manual
Page 21: Maintenance
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
maintenance
BLOCK OF WOOD
REPLACING CUTTER BLADES
WARNING;
FOR
YOUR
OWN
SAFETY,
TURN
SWITCH "OFF" AND REMOVE PLUG FROM POWER
SOUFiCE
OUTLET
BEFORE
ADJUSTING.MAINTAIN-
SNG, OR LUBRICATING YOUR JOINTER-PLANER.
1. Remove belt guard.
2. Position fence to right . , . approximately 1/4 in,
beyond cutter blades . . . lock it in place.
3. Lower infeed table all the way down.
4. Place block of wood 6-3/4 in. long between cutter-
guard and tence.
5.
Hoid cutterhead pulley firmly with one hand and
loosen lockscrews in each wedge using a 5/32 in.
setscrew wrench.
BLADE
LIFTER
SCREW
WEDGE
LOCKSCREW
WEDGE
HOLD
PULLEY
FIRMLY
FENCE NOT SHOWN
FOR PICTURE CLARITY
6. While holdirtg cutterhead pulley firmly with one hand,
gently pry up each wedge using a screwdriver ... re
move wedges and blades.
SMALL SCREWDRIVER
21