Cabletron Systems ELS100-24TXG - Manual (Page 82)

68 SNMP Management ELS100-24TXG
various system, switch, and port level information. System information
MIB variables are shown in Table 5-1, switch information variables in
Table 5-2, and port variables in Table 5-3.
Table 5-1. System Information Variables
Table 5-2. Switch Information Variables
continued on next page
Variable Description
SerialNo Serial number of the unit.
TftpIpAddress TFTP server IP address for TFTP downloads.
TftpFilename Filename of the download upgrade file on the TFTP server.
PowerUpCount Cumulative number of times switch has powered up or
been reset.
BroadcastCutoffRate Per second rate past which broadcast and destination un-
known unicast frames are not flooded on each group of 8
10/100 ports and each Gigabit Ethernet port on the switch.
GatewayIPAddress IP address of the default gateway (router) to which packets
destined for another subnet are sent.
TftpStartDownload Start TFTP downloads via SNMP, using TftpIpAddress and
TftpFilename.
BootpDhcpEnable Enable/disable BootP/DHCP for IP address configuration.
Reset Remotely execute a software reset of the switch.
Variable Description
SwitchIpAddress IP address of the switch, used for management.
SwitchSubnetMask Subnet mask corresponding to the SwitchIPAddress.
ActiveAgingTime Aging tick period in seconds by which addresses in the for-
warding table are aged out.
SwitchStpStatus Enable/disable operation of Spanning Tree on the switch.
SwitchManager List of SNMP trap manager IP addresses.
SwitchTrapRcvr1 SNMP trap manager IP address #1.
SwitchTrapCommunity1 SNMP community associated with trap manager
IPaddress #1.
SwitchTrapRcvr2 SNMP trap manager IP address #2.
SwitchTrapCommunity2 SNMP community associated with trap manager
IP address #2.
SwitchTrapRcvr3 SNMP trap manager IP address #3.
SwitchTrapCommunity3 SNMP community associated with trap manager
IP address #3.
SwitchTrapRcvr4 SNMP trap manager IP address #4.
SwitchTrapCommunity4 SNMP community associated with trap manager
IP address #4.
SwitchPortMirroring Status Enable/disable port mirroring operation of the switch.