Cabletron Systems ELS100-24TXG - Manual (Page 42)

28 ELS100-24TXG User Interface ELS100-24TXG
System Configuration Menu
The System Configuration Menu enables modification of system-level
switch configuration parameters. Select a from the Main Menu to view the
System Configuration Menu. Figure 3-4 shows the System Configuration
Menu and the accompanying table describes the System Configuration
Menu.
Figure 3-4. System Configuration Menu
SYSTEM CONFIGURATION Access Control: READ/WRITE
a. SNMP Configuration Menu
b System Name
c. System Location
d. System Contact
e. IP Address
000.000.000.000
f. Subnet Mask 000.000.000.000
g. Default Gateway 000.000.000.000
h. BootP/DHCP Enable Yes
i. Screen Timeout (minutes) 0
j. Password None
k. Terminal Baud Rate 9600
l. Terminal Hardware Flow Control No
x. Previous Menu
Enter Selection:
Selection Description
SNMP Configura-
tion Menu Menu for configuring SNMP-related parameters.
System Name The switch administrative name (1-36 character range).
System Location The physical switch location (1-36 character range).
System Contact The switch contact person (1-36 character range).
IP Address The IP address of the switch.
Subnet Mask Subnet mask associated with the switch IP address.
Default Gateway The default gateway (or router) to which the switch sends IP
packets destined for a different subnet.
BootP/DHCP
Enable Allows you to enable (Yes) or disable (No) the BootP and DHCP
protocols for automatically configuring the switch’s IP address
information.
Screen Timeout
(minutes) The duration of time before a serial console or Telnet session
terminates due to user inactivity (0-65535 numeric range). A
value of “0” means that the screen will not terminate at any time.
Password Allows “read/write” access to the user interface, via the serial
console or Telnet (1-10 character range).
Terminal Baud Rate Serial console baud rate (2400, 9600 or 19200).
Terminal Hardware
Flow Control Allows you to enable (Yes) or disable (No) hardware flow con-
trol on serial console interface. Signals DTR, RTS and CTS are
used for this purpose. Flow control should be enabled if using
external modem.