Viconics VZ7656E Installation Guide - Manual (Page 14)

14 | VZ7656E1000W Installation Guide
D) Schedule set (2 events)
Scheduling can have 2 or 4 events per day. This is set in the configuration menu as per
parameter; (2/4event).
Schedule
set Y/N
This section of the menu permits the user to set the weekly schedule for all the zones
attached to the RTU controller. Each day can be tailored to specific schedules if needed.

2 events can be configured per day.

Occupied & unoccupied periods can be set for each day.
MONDAY TIMER
SCHEDULE SET
TUESDAY
TIMER
SCHEDULE SET
WEDNESDAY
TIMER
SCHEDULE SET
OTHER DAYS ARE
IDENTICAL
Monday
set? Y/N
No next

Yes down

Tuesday
set? Y/N
No next

Yes down

Wednesda
set? Y/N
No next

Yes down

Selects the day to be scheduled or
modified
Yes key to access day scheduling, No key to jump to next day
Occupied
Day? Y/N
No next

Yes down

Occupied
Day? Y/N
No next

Yes down

Occupied
Day? Y/N
No next

Yes down

Yes = Daily schedules will be
accessed
No = Unoccupied mode all day
Yes key to access day scheduling, No key to jump to next day
Copy Y/N
Previous
Yes next

No down

Copy Y/N
Previous
Yes next

No down

Yes = Will copy previous day
schedule
No = Daily schedules will be
accessed
Yes key to copy previous day, No key to set new time value for each day
Occupied
00:00 AM
Use ▲▼
To set
value
Occupied
00:00 AM
Use ▲▼
To set
value
Occupied
00:00 AM
Use ▲▼
To set
value
Sets Event # 1 Occupied time
Will activate occupied setpoints
Use ▲▼ to set value, Yes key to confirm
Unoccup
00:00 AM
Use ▲▼
To set
value
Unoccup
00:00 AM
Use ▲▼
To set
value
Unoccup
00:00 AM
Use ▲▼
To set
value
Sets Event # 2 Unoccupied time
Will activate unoccupied setpoints
Use ▲▼ to set value, Yes key to confirm
Typical examples of a 2 event office schedule
Ex. #1 Office building closed all weekend
Event Period #1 - Event #1 Period #1 - Event #2
Occupied Unoccupied Daily Occupancy
Monday 7.00 AM 6.00 PM Day time only
Tuesday 7.00 AM 6.00 PM Day time only
Wednesday 7.00 AM 6.00 PM Day time only
Thursday 7.00 AM 6.00 PM Day time only
Friday 7.00 AM 6.00 PM Day time only
Saturday 12.00 PM * 12.00 PM * Unoccupied
Sunday 12.00 PM * 12.00 PM * Unoccupied
* Configuring consecutive events to the same time will cause the controller to choose the
last event as the time at which it will set its schedule. In the above example, the
controller will control the unoccupied set point until 7:00 AM Monday.
Note: 12:00 PM = Noon
12:00 AM = Midnight