VACUUBRAND BVC professional G - Manual (Page 61)

page 61 of 68
fuse holder
➨
Keep the snap-fit squeezed and pull the fuse holder out.
➨
The fuse holder contains two fuses of the same type. Replace the de-
fective fuse by a fuse of the same type (see ”Technical data”)
➨
Insert the fuse holder into the housing of the pumping unit until it snaps.
Replacing the fuse
➨
Switch off the pump.
➨
Disconnect the electrical power cord before opening
the terminal box. After disconnecting from power, wait
5 seconds to allow the capacitors to discharge.
+
Identify and eliminate the cause of failure before switch-
ing on the equipment again.