USL CM-10 - Manual (Page 14)

- 14 -
Crossover Bypass Setup
This unit can be equipped with either the XTD-680D, a fully digital triamp
crossover card, the XTA-680EA, an analog biamp crossover card or the XTB-
680B, a bypass card when no crossover functions are desired with the monitor.
The XTD-680D and the XTA-680B are discussed in detail in their own instruction
manuals.
1. Bypass Card XTB-680B: When using external crossovers, the CM Series
must be equipped with a bypass card in the crossover slot.
For external crossovers or crossovers built into amplifiers:
Turn biamp switch “ON”, triamp “OFF”.
Feed the channel “A” output of the
Lm/Lh, Cm/Ch, and Rm, Rh HD15
connectors to the appropriate amps.
OR
Feed the Lm, Cm and Rm terminals on
the Phoenix connectors to the
appropriate amps.
To USE CP-650 internal crossover with CM Series Monitors.
For biamp operation, turn biamp
switch to “ON”and triamp switch “OFF”.
Make sure switches J-O on the chassis
are “OFF”.
For triamp operation, turn triamp
switch to “ON”and biamp switch “OFF”.
Make sure switches J-O on the chassis
are “ON”.
BIAMP
TRIAMP
ON OFF